11.1.6 Scan features
Feature/Code Selection
Setting the scan mode for
Push Scan
MBNM4NM9NM3N
M1N “VIEWER” (default): The scanned image will be displayed in the
[Multi-Function Viewer] window.
M2N “FILE”: The scanned image will be saved as a file.
M3N “EMAIL”: The scanned image will be saved for email attachment.
M4N “OCR”: The scanned image will be displayed in the OCR window.
M5N “EMAIL ADDRESS”: The scanned image will be sent as an attachment
without using email software.
M6N “FTP SERVER”: The scanned image will be sent to the pre-programmed
folder on the FTP server.
M7N “SMB FOLDER”: The scanned image will be sent to the pre-programmed
SMB folder.
Note:
R Following selections will be displayed only when the server setting is
programmed through the web browser interface in advance.
– “EMAIL ADDRESS” will be displayed when the email server setting is
programmed (page 97).
– “FTP SERVER” will be displayed when the FTP server setting is
programmed (page 92).
– “SMB FOLDER” will be displayed when the SMB folder setting is
programmed (page 93).
Holding the previous
scanning parameter for Push
Scan
MBNM4NM9NM4N
M0N “DISABLED” (default): Deactivates this feature.
M1N “ENABLED”: The unit will hold the previous scan settings for each mode of
push scan.
Setting the information for
scan to FTP (LAN connection
only)
R This feature can be
programmed only through
the web browser interface.
When you send scanned files to an FTP server, you can register the FTP
destinations (up to 6 destinations) to the unit through the web browser interface.
1. Start Multi-Function Station.
2. [Utilities] A [Configuration Web Page] A [Device Configuration]
3. Type “root” as the user name, then enter the password (feature #155 on
page 79). A [OK]
4. Select the [SCAN FEATURE] tab.
5. Click [Edit] next to [FTP SERVER].
6. Click [Edit] next to the desired FTP server.
7. Enter the server name, IP address, folder directory, etc. A [Submit]
8. Close the web browser.
Note:
R If you do not enter a folder directory in step 7, the scanned image will be
saved in the root folder.
92
11. Programmable Features
