Programming the Unit
Using Conferencing
Phone Manager
1. Start Conferencing Phone Manager (see page 57).
2. Click the icon (
) in the upper-left corner of the
front panel screen.
• The programming screen is displayed.
3. Click the desired programming category name on
the left side of the screen.
• The corresponding parameters are displayed
on the right side of the screen.
4. Change the parameters as desired.
5. Click [OK].
• The front panel screen is displayed again.
• To cancel without changing any settings, click
[Cancel].
Note
• If the unit must be restarted before the new
settings become effective, a dialog will prompt
you to restart the unit. Click [Yes] to restart the
unit.
Restarting the Unit Using
Conferencing Phone
Manager
1. Click the icon (
) in the upper-left corner of the
front panel screen.
• The programming screen is displayed.
2. Click [Restart].
3. Click [Restart], then click [Yes].
• The front panel screen is displayed again.
58 Operating Instructions Document Version 2008/10
Conferencing Phone Manager
