A SERVICE OF

logo

Open as PDF
next previous
Hand Scanner Functions
Preparations
1
Scanning documents
2
1. Remove the cover.
1. Turn the power (power switch) ON.
2. Select the resolution. ( text, photo)
3. Set (operation) to the “ ” (scan)
position.
4. Set the hand scanner on the document.
5. Press (start/stop).
6. Move the hand scanner slowly
over the document.
Left side of
the document
Max. 208 mm
Scanner
position
2. Install the alkaline batteries (included).
9
Power Indicator
Flashes (Red)
Lights (Red)
Does not light
Power Switch
The battery power is low.
Replace the batteries.
Replace the batteries.
Memory is empty.
The battery power is full.
Memory Indicator
Memory Indicator
7. Press (start/stop) to end the operation.
8. Turn the power (power switch) OFF.
Max. 1.5 m
– A beep is heard.
– The In Use indicator light turns on (green).
– If you want to scan the document again,
set (operation) to the “ ” (erase)
position.
Then repeat from
step 3.
Scanning
direction
Power
Indicator
33% of memory is used.
66% of memory is used.
99% of memory is used.
Memory is full.
Cover
Power Indicator
In Use Indicator
Memory Indicator
(power switch)
(operation)
(resolution)