Prog. RF Ch
Service Name Net ID. TS ID. Quality
This will take about 3 mins.
•
Auto Tuning
•
Connection
Connection
External equipments and cables shown in this manual are not supplied with this TV.
Please ensure that the unit is disconnected from the mains before attaching or disconnecting any leads.
Need help
with operations?
(example: Sound menu)
On-screen operation
guide will help you.
select
Note
•
Do not put the Coaxial cable close to
the mains lead to avoid noise.
•
Do not place the Coaxial cable under
the TV.
•
To obtain optimum quality picture and
sound, an Aerial, the correct cable (75
Ω
coaxial) and the correct terminating
plug are required.
•
If a communal Aerial system is used,
you may require the correct connection
cable and plug between the wall Aerial
socket and the TV.
•
Your local Television Service Centre
or dealer may be able to assist you
in obtaining the correct Aerial system
for your particular area and the
accessories required.
•
Any matters regarding Aerial
installation, upgrading of existing
systems or accessories required, and
the costs incurred, are the responsibility
of you, the Customer.
75
Ω
Coaxial cable
Rear of the TV
VHF / UHF aerial
■
Watching TV
■
To record TV
programmes
DVD Recorder or VCR
Rear terminal
portion
(enlarged view)
Mains lead
(Connect after all the other connections.)
1. Insert the claws (at 3 points) at
the bottom end.
2. Push until it clicks.
Removal Fitting
1. Push down hooks and pull the
cover slightly towards yourself to
disengage the claws (at 3 points).
2. Slowly pull out in the downward
direction.
■
Cable cover removal and fi tting
Turn the TV On with the On / Off switch
Usable characters and numbers
1
Auto Tuning
Following the on-screen operation
guide, enter your own choice of PIN
number, name, etc.
•
For detailed procedures
"Owner ID" (p. 26)
•
Make a note of the PIN number
in case you forget it.
Search and store TV channels automatically.
These steps are not necessary if the setup has been completed by your local dealer.
Input owner ID
DVB Auto Tuning is now complete and your TV is ready for viewing.
■
When inputting owner ID later
•
From now on you can use the
remote control to turn On the TV
or turn the TV to standby mode.
4
•
If you input the ID later
"Owner ID" (p. 26)
•
Auto Tuning will start to search for
digital TV services and store them.
•
To check service list at-a-glance
TV Guide (DVB) (p. 12)
•
To edit analogue channels
"Programme edit" (p. 24)
•
The sorted service order depends
upon the TV signal, the broadcasting
system and reception conditions.
Note
•
If tuning have failed, perform
"Auto Tuning" (p. 22).
•
If it is not the fi rst time to
perform Auto Tuning, all
previous tuning data will be
erased.
Select your state
2
Start Auto Tuning
3
This TV has been pre-tuned by the factory to the
following Analogue TV channels.
If your location does not
receive these channels,
perform "Auto tuning" (p. 24).
start
or
Programme No. Channel No.
110
22
328
77
99
31 31
