ˊˇʳʳʳ˅ˇ˃ˣ˪ˌʳʳ˟˖˗ʳ
General Product Specification
• All major plastic parts (bezel, back cover) need to be molded from same resin.
• Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
5.12 Texture/Glossing of housing
ʳ
ʳʳ
ʳ
• The texture area and texture no should follow Philips make-up sheet.
• The exterior surfaces shall have a uniform texture.
•
Philips must approve the mold texturing.
• Detail document for texture refer to “UN-D249”, “UN-D 600”.
• < = 20 gloss units
5.13 Tilt and swivel base
• Tilt angle : -3.5 ° + 1.5/- 1.5 ° (forward)
+21.5 °+ 1.5/- 1.5 ° (backward)
• Swivel angle :
̈́ʳˇˈ̓
• High Adjustment : total 130mm
• Portrait Display : 0
̓~90̓ ( CW direction )
ʳ ʳʳʳʳʳʳʳʳʳ
ʳʳ
ʳ
5.14 Kensington Lock
ʳ
• Must meet Kensington_slot.spec “TYE-M0004”.
• MMD request metal plate in Kensington hole.
5.15 Label
• Regulatory label / Carton label should follow Philips requirement.
• China RoHS label
• Detail document refer to Philips Engineering Reference Book.
ʳ
5.16 Product dimension / Weight ( Refer to Philips approved SHT 191/SHT560 )
• Unit dimension :
ˈˈˋˁˉʳ̋ʳˇˆˇˁˋˊʳ̋ʳ˅˅˃ʳ̀̀
• Packed unit dimension:
ˊˈˆʽˇˌ˃ʽ˅ˊˊʳ̀̀
• Net weight :
ˋˁ˄˅ʳ˞˺
