TV SETUP MENU & SUB-MENUS (CONTINUED)
. The digital tuner will ignore the Virtual Channel Table (VCT) information that is contained
in the Program and System Information Protocol (PSIP) during channel installation or Direct Channel Command which is sent by
When VCT is ignored, the digital tuner will tune to the physical channel, Radio Frequency (RF) Channel. Program Map Table
(PMT), which is stored as channel number Major dot Minor (eg. 2.1) in the TV set. The virtual channels will not be used in this
. Program and System Information Protocol (PSIP) is used during channel installation, and
The digital tuner will use the virtual channel information that is contained in the PSIP, to map the virtual channels to the physical
channels, which is also called Major dot Minor channel in this case.
For more information on the PSIP, you can refer to ATSC Standard, Program and System information Protocol for Terrestrial
Broadcast and Cable (Revision B), which can be found at the website http://www.atsc.org/standards/a_65b.pdf.
. The Digital TV channel number will not be displayed on the screen.
. The Digital TV channel number will be displayed on the top right hand corner of the TV
screen for about 5 seconds whenever there is a change in digital TV channel.
For the changes in the Digital TV label to take effect, please conduct a cold / warm start when the setting is changed from Yes to
Channel edit allows you to add or skip channels from your favorite list.
1
is selected, the channels will
be skipped when scrolling channels with the
is selected, the channels will not be skipped when
scrolling channels with the
When you are in Digital Mode you can only add or skip programs in Digital Channels.
Digital broadcasting is still new. Therefore it is not uncommon for a broadcaster to only send out a digital signal for part
The reception could also come and go. If you program your channels when the signal is not being sent or is
weak it will not be saved in your channel setup. Using the
feature here, you can add those channels
Weak Digital Signal feature here, you can add those channels Weak Digital Signal
with weak or no signals to your channel list.
Weak Digital Signal can Weak Digital Signal
AutoLock (not suppAutoLock
feature lets you erase the contents of the master, user and favorite channel lists. This restores the TV to the
Factory Channel Reset feature lets you erase the contents of the master, user and favorite channel lists. This restores the TV to the Factory Channel Reset
initial state before the first Auto Program operation
For instructions on how to Auto Install the TV again, refer to page 12.
allows you to switch to another audio language when it is available.
lets you select the default option or options that you have assigned to your Close captioning service.
available in Digital Mode.
ONLY available in Digital Mode.ONLY
lets you display or discard emergency alerts for Low or Medium priority.
mergency Alert lets you display or discard emergency alerts for Low or Medium priority. mergency Alert
Emergency Alert will not be visible if no broadcast is received or when the TV is in Standby mode.
Entering the DTV SETUP menu allows you to edit features while you are in Digital TV mode.
