1 Touch SETUP and VISUAL and then
touch PARENTAL.
2 Touch 0 to 9 to input the registered
code number.
3 Touch ENTER.
This enters the code number, and you can now
change the level.
# If you input an incorrect code number, the
icon is displayed. Touch C and input the cor-
rect code number.
# If you forget your code number, refer to If you
forget your code number on this page.
4 Touch any of 1 to 8 to select the desired
level.
The new parental lock level is set.
If you forget your code number
Refer to Changing the level on the previous
page, and touch C 10 times. The registered
code number is canceled, letting you register
a new one.
Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Press A.MENU button and touch INIT to
display the initial function names.
The function names are displayed and oper-
able ones are highlighted.
# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# When the multi-channel processor (e.g., DEQ-
P8000) is connected to this unit, you can operate
D. ATT and RESET instead of REARSP.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Operating this unit
En
38
Section
03
