1-28 2001 Pontiac Aztek
Door Frame Sectioning—Outer
(Rocker Sectioning)
Installation Procedure con't
6. Prepare all attachment surfaces as
necessary.
7. Apply weld-thru primer to all bare-
metal surfaces.
8. Fit the backing plate (1) halfway
into the sectioning joint (2). Clamp
and plug weld to the vehicle.
9. Align the Rocker Panel using three-
dimensional measuring equipment.
10. Plug weld accordingly.
11. To create a solid weld with
minimum heat distortion, make 25
mm (1 in.) stitch welds along the
seam with 25 mm (1 in.) gaps
between them. Then go back and
complete the stitch weld.
IMPORTANT: Prior to refinishing,
refer to publication GM4901M-D-01
GM Approved Refinish Materials for
recommended products. Do not
combine paint systems. Refer to
paint manufacturer’s
recommendations.
12. Clean and prepare all welded
surfaces.
13. Apply the following as necessary:
• Anti-corrosion materials
• Sound deadeners (1)
• Sealers
14. Refinish as necessay.
15. Install all related panels and
components.
25MM
(1 IN)
1
2
1
1
1
