Inserting
Batteries in the Remote
Remove the cover of battery cabin on the back of the remote control by lifting the cover
Insert two AAA batteries making sure the polarities (+ and ) are aligned correctly
Place the cover back
If the remote control does not work, check these points:
• Are the polarities (+) correct?
• Are the batteries worn out?
• Is there an AC power failure?
• Is the power cord plugged in?
• Is there any interference or block near the remote
control sensor?
CAUTION:
• Used batteries should be recycled
• Keep out of children's reach
• DO NOT use new and old batteries together
• Change both the batteries at the same time
• When not using the remote control for a long time
remove the batteries from the unit
Remote Control Reception Angle
Use your remote control within the distance and angle range shown below
7 meters
J
16
