RCA DRC6389T Manual

A SERVICE OF

next previous

GB - 17

Playing a Disc

1.SlidetheCHARGE/STANDBY/ONswitchtotheONposition.SlidetheON

/OFFswitchonthemonitortotheONposition.SeeCUSTOMIZINGTHE

FUNCTION SETTINGS before proceeding to step 2.

2. Pull down front panel to open the disc door.

3. Hold the disc by its sides and gently push it onto the spindle, with label side

facingtowardyouuntilyouheara“click”.

4. Gently push the disc door closed. It takes a short while for your unit to load

the disc. After loading, for most DVDs, the unit will automatically take you main

menu or start playing. If the unit does not automatically start playing the DVD,

press the PLAYbutton.

Pausing Playback (Still Mode)

Press the PAUSE button. To resume normal playback, press the PLAY

button.

Each time you press the PAUSE button, the picture advances one frame.

Stopping Playback

Press the STOP button at the location where you want to interrupt playback. To resume playback at the

position where the disc was stopped, press the PLAYbutton.

If you press the STOP button twice, the unit’s memory will be cleared and pressing the PLAYbuttonwill

reset the disc to the beginning.

Fast Forward / Fast Reverse

1. Press the SEARCH or SEARCH button when a disc is playing. Each time you press the SEARCH

or SEARCH button, the playback speed changes in the following sequence:

2. Press the PLAYbuttonwhenyoureachthedesiredpointtoresumenormalplayback.

Note:

• TheDVDplayermutessoundandsubtitlesduringreverseandforwardscanofDVDs.

• Thefastplaybackspeedmaydifferdependingonthedisc.

Skip (Forward / Reverse)

• Pressthe PREVbuttontogobacktocurrentorpreviouschapters/tracks.

• Pressthe NEXTbuttontoadvancechapters/tracks.

• ForaudioCDs,usethenumberbuttonsontheremotecontroltojumpimmediately

to the desired track number.

Audio Selection

On some DVDs, the sound is recorded in two or more formats. Follow the directions below to select the

preferred language and sound system.

1. While a disc is playing, press the AUDIO button to show the current audio format number.

2. Press the AUDIO button repeatedly to select the desired audio format.

Note:

• IfonlyoneaudioformatisrecordedontheDVD,thenumberdoesnotchange.

• SomeDVDsallowyoutochangeaudioselectionsusingthediscmenuonly.Ifthisisthecase,pressthe

MENU button and choose the appropriate language on the disc menu.

• Youcanselectdifferentaudiochannels(Stereo,LeftorRight)onanAudioCDbypressingtheAUDIO

button repeatedly.

This owner’s manual explains the basic instructions

for operating this unit. Some DVDs are produced in

a manner that allows speciﬁc or limited operation

during playback. Therefore, this unit may not

respond to all operating commands. THIS IS

NOT A DEFECT. Please refer to the instructions

accompanying the speciﬁc DVD in question for

more information about the options available on

that DVD.

“ ”mayappearonthescreenduringoperation.

A“ ”meansthatthedesiredoperationisnot

permitted by the unit or disc.

PLAYING A DISC

Basic playback