Position the satellite receiver.
Position the receiver on top of the VCR. You
may need to position it at different angles
before the VCR can control it. Make sure the
receiver does not cover the transmitting
window on top of the VCR.
A. Basic hookup.
Use this hookup if your TV does not have
audio/video jacks.
1. Set the CH3 CH4 switch on back of
satellite receiver to either channel 3 or 4.
You will tune the VCR to this channel or
its line input (L1) to record from the
satellite receiver. To watch the satellite
receiver, turn off the VCR. If you want to
watch or record the signal from your
antenna, cable, or cable box, make sure the
satellite receiver is turned off.
2. Set the CH3 CH4 switch on back of VCR
to either channel 3 or 4.
You will tune the TV to this channel and
use the TV•VCR button to watch the VCR.
3. Connect as shown.
This connection may require additional
accessories not provided.
4. Plug in power cords of VCR, TV, and
receiver.
5.
Go to ÒStartupÓ section.
A
Transmitters
Remote Sensor
Satellite Receiver
Caution: The unauthorized recording of satellite
broadcasts, television programs, or other
materials may infringe the rights of others.
