FPI FireGenie
TM
Remote Control Manual8
AUTO MODE
There is a 3-minute delay built into the Remote Control. This delay will affect the AUTO and PROG modes
only. Which means the unit may not respond to specific instructions instantly when in either of these 2 modes.
Note: Ensure the Remote Control has been turned ON in order to operate in this mode.
In Auto Mode the Remote Control operates as a thermostat to turn the fire on and off depending on what
temperature setting it has been programmed to.
Auto mode can be selected by pressing and releasing the AUTO/MAN button until the symbol AUTO is
shown on the LCD.
In Auto mode, when either the + or - button is pressed, the Set Temperature will be displayed on the LCD
instead of the Room Temperature. The Set Temperature will remain displayed on the LCD for 5 seconds after the
button is released and then the display will revert to show the Room Temperature. The Set Temperature can be
adjusted while it is displayed using the + and - buttons.
The LCD will show the following when either the + or - button is pressed:
MANUAL MODE
Note: Ensure the Remote Control has been turned ON in order to operate in this mode.
Manual mode can be selected by pressing and releasing the AUTO/MAN button until the symbol MANUAL
is shown on the LCD.
In Manual mode, the Flame can be turned on and off using the Remote Control via the ON/OFF button.
Room
Set
Auto Mode normal
display
When “+” or “-”
button is pressed
