Regency P33 Sunrise Gas Fireplace
Maximum: 40 ft. (12.2m)
Minimum 9’6” (2.9m)
Minimum 8’6” (2.6m)
Max. 10’ (3m)(centerline to centerline)
Minimum 12” (305mm)
Maximum: 27 ft. (8.2m)
0
2
4
6
40
8
10
12
14
16
18
20
22
24
26
28
30
Vertical Height (Feet)
32
34
36
38
6
8
2
0
4
10 12 1
14
16
2
4
6
8
10
12
14
2
0
0
12
20
6
14
30” (762mm)
Minimum
Height
Requirement
26” (660mm) - Flex
- Rigid
4
8
10
18
16
Vertical Height (Feet)
Horizontal (Feet)
8"(0.2m)
2’ (0.6m)
Venting Arrangements - Horizontal
Terminations
This lightly shaded area of the diagram shows allowable combinations of
vertical runs with horizontal terminations, using one 45° and one 90° elbow
(two 45º
elbows equal one 90° elbow).
Note: Must use optional rigid pipe adapter (Part # 510-994) when using
Rigid Pipe.
• Maintain clearances to combustibles.
• Horizontal vent must be supported every 3 feet.
• Firestops are required at each fl oor level and whenever passing through
a wall.
A vent guard may be required as per local codes, refer to Exterior Vent
Termination Locations.
Note: FPI Direct Vent System (Flex) is only approved for horizontal
terminations.
P33 Sunrise Gas Fireplace
Venting Arrangements - Vertical
Terminations
Rigid Pipe System
(Propane & Natural Gas)
The P33 is approved for a maximum 40 ft. straight vertical, with Rigid
Pipe vent systems for Propane and Natural Gas.
The lightly shaded area,
6
8
2
0
4
10
0
2
4
6
40
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
12
, in the diagram shows allowable venting
confi gurations with a maximum two 45° elbows.
The darker shaded area,
6
8
2
0
4
10
0
2
4
6
40
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
12
, in the diagram shows allowable venting
confi gurations using one 45° and one 90° elbow.
• Vent must be supported at offsets.
• Horizontal sections must be supported every 3 feet.
• Firestops are required at each floor level and whenever
passing through a wall.
• Maintain clearances to combustible materials.
• Minimum of 1’ pipe section between elbows.
Note: Must use optional rigid pipe adapter when using Rigid Pipe
(Part # 510-994).
Note: Height measured from the base of the unit.
Note: Height measured from the base of the unit.
