Troubleshooting
(continued)
129
Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices
Convenient
Functions
Information
/ Display
Checking /
Preparations
Problems with the Sound
Problem
Cause and Action
See
Page
No sound
●
Could the connections be incorrect?
➔
Make the correct connections.
44, 49,
52
●
Could the power on the connected equipment (mic, digital piano, etc.)
be switched off?
➔
Turn on the power.
—
●
Could the volume of the connected device be turned down?
➔
Raise the volume of the connected device.
—
●
Could headphones be plugged in?
➔
Unplug the headphones.
—
●
Is the volume set to the minimum?
➔
Use the [VOLUME] knob to raise the volume.
72
●
Could the speakers be muted (turned off)?
➔
Press the [Speaker] button so they’re turned on.
76
●
Could the [ ](Record) button be blinking or lit?
➔
In recording-standby mode or while recording, there will be no sound
from the speakers. Use headphones if you want to monitor the sound
during recording.
—
The input source (audio
source) is not output
●
Could the input level be turned down?
➔
If you’ve connected external mics, turn the [MIC] knob to raise the input
level.
➔
If you’re inputting audio via the LINE/PHONO IN jacks, turn the [LINE/
PHONO] knob to raise the input level.
45
50, 56
●
Could MIC SELECT be set to “Internal
”
?
➔
The sound from the internal mics won’t be heard from the speakers. Use
headphones if you want to monitor the sound of the internal mics.
40
●
Could MIC SELECT be set incorrectly?
➔
If you want to record using the internal mics, set to “INT.”
➔
If you want to use external mics for your recording, set to “EXT.”
40
44
Insufficient volume from
a device connected to
the EXT MIC
(L/MONO, R)
/LINE/PHONO IN jacks
●
Could you be using a connection cable that contains an internal
resistor?
➔
Use a connection cable—such as one from the Roland PCS series— that
does not contain an internal resistor.
—
●
Could the external mic’s sensitivity be set to “Low”?
➔
If the sound from the external mic is still not loud enough even after
you’ve adjusted the input level, set the “EXT MIC Sens” to “High.”
47
CD-2i_e.book 129 ページ ２０１０年３月１５日 月曜日 午前１０時１５分
