25
Menu Description and Navigation
When the MENU button is pressed on either the remote control or the front panel, the main menu will
appear on-screen. An example of the main menu is shown above.
Opening Screen
• Press ENTER to access the Input Source selection menu
• Press ENTER to access the Aspect Ratio selection menu
• Press ENTER to access the Picture setting menu
• Press ENTER to access the Input Position setting menu
• Press ENTER to access the ISF and Custom Presets menu
• Press ENTER to receive information about the controller
The active source is indicated by an arrow to the left of the source; note that in the example to the
right, Composite is the current source.
Input Source
Indicates selection has been made for the Input Source selection menu
• Press ENTER to select the Composite input
• Press ENTER to select the S-Video input
• Press ENTER to select the Picture setting menu
• Press ENTER to select the Input Position setting menu
• Press ENTER to select the ISF and Custom Presets menu
• Press ENTER to receive information about the controller
To select a source via the main menu, press either the up or down buttons
on the remote or front panel and highlight the desired source, and press
ENTER. Otherwise, you may select a source by pressing either the left or
right arrow buttons (on the remote or front panel) when no menus are
on-screen, or by pressing one of the direct access buttons on the remote
control (recommended).
NOTE: If DVI input is used with HDCP content, RGBHV output is automatically disabled.
This is in compliance with HDCP regulations.
If pass-through is selected, note that no on-screen menus will be displayed since the signal is simply
being 'looped' directly to the output. When pass-through is the selected source, pressing MENU will not
automatically select the last selected input before Pass-through was selected. If you wish to choose
another source, Runco recommends using the direct access buttons to select the desired source as
opposed to pressing MENU.
