Install the cutting attachment shield
when using the unit as a grass
trimmer.
WARNING: To avoid serious
personal injury, the cutting
attachment shield SHALL be in
place at all times while operating the
unit as a grass trimmer.
Install the cutting attachment shield on the
shield mount by inserting the three (3) screws
into the shield mount. Tighten securely with a
flat blade screwdriver (Fig. 7).
ASSEMBLY INSTRUCTIONS
11
REMOVING AND INSTALLING
CUTTING ATTACHMENT SHIELD
Remove the cutting attachment shield
when using the unit as a brushcutter.
WARNING: The cutting attachment
shield should NOT be installed when
operating the unit with a blade.
Remove the cutting attachment
shield before removing or installing
the blade.
Remove the cutting attachment shield from the
shield mount by removing the three (3) screws
with a flat blade screwdriver (Fig. 7). Store parts
for future use.
3. Snap it on to the support fitting (Fig. 5).
INSTALLING THE HARNESS
WARNING: Always use the shoulder
harness when using the cutting
blade to avoid serious personal
injury.
1. Push the strap through the center of the
buckle.
2. Pull the strap over the cross bar and down
through the slot in the buckle (Fig. 4).
(3) Screws
Cutting
Attachment
Shield
Shield Mount
Fig. 4
Fig. 5
Fig. 7
Support Fitting
Fig. 6
4. Adjust length to fit the operator’s size. Pull
tab to lengthen, pull strap to shorten (Fig 6).
