4
English
PARTS NAMES
9
8
6
7
5
F
G
H
5
Camera setup section
6
White balance adjustment volume (R or B)
7
Line phase adjustment volume (PHASE)
8
Lens iris adjustment volume
9
Lens iris output connector (LENS)
This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type
lens.
F Video output connector (VIDEO OUT: BNC type)
Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector.
G
24 V AC or 12 V DC input terminal (AC24V, DC12V, GND)
H
Power indicator (POWER)
Comes on when the power to the camera is on.
■
■■
■ Power supply connections
Use a 3 wire grounded cable (22 AWG or more), and connect as shown by the illustration.
CAUTION:
• To prevent camera and/or AC adaptor failure, pay close attention to polarity when making
the connections.
• To prevent fire hazard any UL listed wire rated VW-1, should be used for the 24 V AC cable
input terminal.
vcc4115p(gb).fm 4 ページ ２００２年９月５日 木曜日 午後３時５９分
