3. Highlight the number you wish to extract.
4. Press to display the options.
5. To select an option, highlight it and press .
ⅷ
Call to dial the phone number.
ⅷ
Call:Speaker On to dial the phone number in speakerphone
mode.
ⅷ
Save Phone# to save the phone number if it is not already in
your Contacts list. If the phone number has already been
stored in a Contacts entry, Go to Phone Book appears instead
of Save Phone#.
ⅷ
Display Phone# to display the phone number.
ⅷ
Prepend to add numbers to the beginning of the phone
number.
Note:Press and hold during step 4 above to start a PCS Ready Link call if
the extracted number is 10 digits ( or 11 digits beginning with 1).
Prepending a Phone Number From a Message
After you display a Message, press to display message options.
To prepend an area code to an extracted number if you happen to be
outside your local area code and need to add a prefix:
1. Highlight Prepend and press .
2. Enter the digits or pauses (see below) you want to add to the
number. If you want to save the number, press and select
the Save Phone# option. If not, the changes only apply to the
current call.
3. To select an option, highlight it and press .
ⅷ
Call to dial the phone number.
ⅷ
Call:Speaker On to dial the phone number in speakerphone
mode.
ⅷ
Save Phone# to store the phone number in your Contacts
Directory.
ⅷ
Hard Pause to insert a hard pause. (See “Dialing and
Saving Phone Numbers With Pauses” on page 24.)
ⅷ
2-Sec. Pause to insert a 2-second pause. (See “Dialing and
Saving Phone Numbers With Pauses” on page 24.)
T
H
Section 3: Using PCS Service Features
3B: PCS Vision 148
