SECO-LARM U.S.A., Inc. 3
Rack mount power supply ........................................................................................................... 1x
Cable management brackets ...................................................................................................... 2x
Cable management hooks ........................................................................................................... 2x
M3x6 Cable bracket screws ......................................................................................................... 4x
Mounting brackets:
16-channel models (rack/wall/surface mount) .................................................................................... 2x
32-channel models (wall and surface mount only) ............................................................................... 4x
Extra-long rack mount brackets (32-channel models only) .................................................................. 2x
Rubber feet .................................................................................................................................. 4x
Power cord .................................................................................................................................. 1x
Front panel lock tab (Glass Fuse models only) ................................................................................... 1x
Spare fuses (PH-A1612-GUQ only, mounted inside unit, see Installation: Section D) ..................................... 3x
Spare fuses (PH-A3224-GUQ only, mounted inside unit, see Installation: Section D) ..................................... 6x
Spare main fuse (Mounted inside unit, see Installation: Section C) .......................................................... 1x
Manual ......................................................................................................................................... 1x
1. Decide on a location to install the unit, away from moisture, high humidity, heat sources, etc.
2. Make sure there is enough space around the unit so air can flow in and out for cooling
purposes.
3. Be sure ventilation holes are not blocked by other equipment, rack housing, walls, etc.
4. To avoid undesirable operation in either the product or other equipment place the unit at
least 12” (30cm) from any television monitor or other radiation-producing, radiation-sensitive
or heat-producing equipment such as heaters, radiators, etc.
1. Units may be stacked one on top of the other, or with other equipment.
2. Make sure the rubber feet are firmly attached to the bottom of the unit as shown in Figure 10
in the Overview section on page 7, and that no ventilation holes are blocked.
