Sharp R-259 Manual

next previous

Manual abstract:

15 - 17 COOKING ADVICE: Microwave Cooking Advice 18 - 19 Suitable Cookware .20 Defrosting Advice 21 Reheating Advice 22 COOKBOOK .23 - 35

AFTERCARE: Cleaning and Maintenance .36 Troubleshooting .37 To Replace the Mains Plug .38 Calling for Service .38 GUARANTEE .39

SPECIFICATIONS 40 1 UK R-259 O/M,-P28 05.3.24 4:15 PM Page 2 (1,1) OVEN AND ACCESSORIES 9 3 8 7 11 65 4 OVEN: 1.

Oven lamp 2. Control panel 1 3. Door opening handle 4. Waveguide cover (DO NOT REMOVE) 2 5. Oven cavity 6.

Coupling 7. Door latches 8. Door hinges 9. Door seals and sealing surfaces 10. Power cord 11.

Ventilation openings 12. Outer cabinet 12 10 13 14 ACCESSORIES: Check to make sure the following accessories are provided: 13. Turntable 14. Roller stay

· Place the roller stay in the coupling on the oven floor, then place the turntable on to the roller stay, ensuring it is located firmly. · To avoid turntable

damage, ensure dishes or containers are lifted clear of the turntable rim when removing them from the oven. NOTES: · The waveguide cover is fragile. Care

should be taken when cleaning inside the oven to ensure that it is not damaged. · Always operate the oven with the turntable and roller stay fitted correctly.

This promotes thorough, even cooking. A badly fitted turntable may rattle, may not rotate properly and could cause damage to the oven.

· The turntable rotates clockwise or anti-clockwise. The rotary direction may change each time you start the oven. This does not affect cooking performance. ·

When you order accessories, please quote both the PART NAME and MODEL NUMBER to your dealer or SHARP approved service facility. WARNING: The

door, outer cabinet, oven cavity, turntable and dishes will become very hot during operation. To prevent burns, always use thick oven gloves. 2 UK R-259

O/M,-P28 05.3.24 4:15 PM Page 3 (1,1) CONTROL PANEL 1. 2.

1 3. 4. 5. 2 6. 7.

8. 9. 3 11 DIGITAL DISPLAY TIME keys EXPRESS COOK keys EXPRESS DEFROST keys LESS/MORE TIME keys POWER LEVEL key START/AUTO

MINUTE key STOP/CLEAR key KITCHEN TIMER/CLOCK SET key 10. WEIGHT keys 11. AUTO COOK key 4 10 5 9 6 7 8 3 UK R-259 O/M,-P28 05.

3.24 4:15 PM Page 4 (1,1) INSTALLATION WARNING: Inspect the Oven: Check the oven carefully for damage before and regularly after installation. Make

sure the door closes properly, that it is not misaligned or warped. Check the hinges and door safety latches are not broken or loose. Ensure the door seal and

sealing surfaces are not damaged. If the door or door seals are damaged, the oven must not be operated until it has been repaired by a competent person.

Inspect the oven interior and door for dents. IMPORTANT: If any damage is apparent, do not operate the oven in any way, until it has been repaired by a

SHARP trained engineer. 5. Make sure the power supply cord is undamaged (See "ELECTRICAL CONNECTION" below).

Do not allow the power supply cord to run over any hot or sharp surfaces, such as the hot air vent area at the top rear of the oven. 6. The socket must be

readily accessible so that it can be easily unplugged in an emergency. 7. Do not use the oven outdoors. BUILDING-IN-KIT. This oven is not designed to be

built into a kitchen unit. ELECTRICAL CONNECTION. · Do not allow water to come into contact with the power supply cord or plug. · Insert the plug

properly into the socket.

· Do not connect other appliances to the same socket using an adaptor plug. · If the power supply cord is damaged, it must be replaced by a Sharp approved

service facility or a similarly qualified person to avoid a hazard. · When removing the plug from the socket always grip the plug, never the cord as this may

damage the power supply cord and the connections inside the plug. · If the plug fitted to your oven is a rewireable type and in the event of the socket outlet in

your home not being compatible with the plug supplied, remove the plug properly (do not cut off)..

Your user manual

SHARP R-259