Command Description
SET NW
AUTHtype
Sets wireless authentication type
The default value is Open System
Format:
SET NW AUTHtype [OPEN | SHARED | TTLS | LEAP | PEAP |
TLS | PSK ]
NOTE: For FIPS 140-2 approved operation, this parameter
must be TLS, PEAP or PSK
SH NW AUTH Shows wireless authentication type
Sample output:
Authentication type= OPEN SYSTEM
SET NW
ETHAUTH
Sets Ethernet wired authentication type
The default value is Open System
Format:
SET NW ETHAUTH [TTLS | TLS | PEAP ]
SH NW ETHAUTH Shows Ethernet wired authentication type
Sample output:
Authentication type= PEAP
SET NW
AUTHTRY
Sets number of times the Serial Device Server will attempt to authentication
The default value is 0.
Format:
SET NW AUTHTRY n
SH NW AUTHTRY Shows number of authentication tries.
Sample output:
Authentication Try Count = 3
SET NW CHannel Sets WLAN ad-hoc channel number
The valid numbers are 1 through 11.
Format:
SET NW CHannel n
SET NW ENC Sets WLAN Encryption Mode.
Supported modes are None, 64 bit WEP, 128 bit WEP, WPA, WPA2, WPA2-WPA
The default value is Disable.
Format:
SET NW ENC [Disable | 64 | 128 | WPA | WPA2 ]
NOTE: For FIPS 140-2 approved operation, this parameter
must be WPA2.
SH NW ENC Shows the wireless encryption mode
The deprecated command SH NW WEP also displays this information.
Sample output:
Console Commands Silex Page 41
Part Number 140-00188-210A
