Spirit XBR25 Manual

next previous

Fitness Bike

XBR25

1. Slide the Computer Cable (44) and Hand pulse Wire (133) through the bottom of the Console Mast Cover

(31) and then the bottom of the Console Mast (2). Make sure the Console Mast Cover is correctly oriented

(see illustration).

2. Install the Console Mast (2) into the receiving tube (make sure not to pinch cables (44) and (133); damage to

the electronics could occur) of the Main Frame (1). Insert two Hex Head Bolts (68) and two Flat Washers (76)

on each side. Insert two Hex Head Bolts and two Curved Washers (83) on the front. Tighten all six bolts rmly

with the wrench (112).

3. Remove the white Styrofoam pad (factory installed to prevent bolts from being accidentally dropped into the

console mast tube).

4. Attach the Handle Bar Assembly (3) onto the Console Mast (2) bracket with the two Hex Head Bolts (68),

two Split Washers (82), and two Flat Washers (76). Completely tighten with the wrench (112).

HARDWARE

STEP 2: Console Mast

#82.8 x 1.5T

Split Washer

(2 pcs)

#83.5/16” x 19 x 1.5T

Curved Washer

(2 pcs)

#68.5/16” x 15mm Hex

Head Bolt

(8 pcs)

#76.5/16” x 18 x 1.5T

Flat Washer

(6 pcs)