1
CHAPTER
1
Setting Up the Server Hardware
This chapter contains the following topics:
■ “Installation Overview” on page 1
■ “Installing the Server Into a Rack With Optional Slide Rails” on page 2
■ “Cabling” on page 13
■ “Powering On and Off the Server” on page 16
Note – The information in this book applies to all Sun Fire™ X4100/X4100 M2 and
X4200/X4200 M2 servers, unless otherwise noted.
Installation Overview
After unpacking your server, perform the following tasks, which are described in the
documentation as indicated:
1. If desired, install the server into a rack using orderable slide-rails. See “Installing
the Server Into a Rack With Optional Slide Rails” on page 2.
2. Connect all cables, peripherals, and power cords. See “Cabling” on page 13 for an
illustration of the server’s back panel connector ports.
3. Power on and boot the server as described in “Powering On and Off the Server”
on page 16.
4. Connect to the service processor as described in Chapter 2.
