161616
Additional Features
Quad View:
In Quad View mode, you’ll be able to see images from up to four cameras on
screen at once. For this to function optimally, you’ll need:
Four ADW-400 cameras,•
connected to power,•
and each correctly paired to each of the four channels.•
To enable quad viewing mode, simply press the QUAD button on the top of the
receiver.
Whilst in Quad Viewing mode, some of the buttons on the receiver will no
longer be active - most notably, the MENU button will not be active. This is
because decoding four video signals simultaneously uses the maximum processing
capacity of the miniature computer in the receiver and there is insuffi cient
processing power to display the menus. To exit Quad Viewing Mode, simply press
the QUAD button again. The full functionality of the MENU button will instantly
return.
You’ll be able to enter Quad Viewing Mode even if there are fewer than four
cameras paired with the receiver. In this case, there will simply be a blank space
where that image would otherwise be displayed.
Auto Delete:
Whilst the Auto Delete function is turned ON, the ADW-400 will automatically
delete old fi les when it runs out of space on the SD card.
As a result, we suggest checking the recording lists periodically to ensure you don’t
lose an important event. (Of course, depending on your unique situation, it may be
extremely obvious when an incident has occurred.)
If Auto Delete is turned off, when the SD card fi lls up, that’s it - new events cannot
and will not be recorded. For most implementations, it’s usually better to be able
to record events as they happen at the risk of losing old ones than vice versa.
However, this is something that you’ll need to determine based on your unique
situation. If Auto Delete is turned on and there is a particular incident that
you want to backup, you’ll need to copy it off the SD card before it is over-
written!
The Auto Delete icon will be displayed
on the screen while Auto Delete is
switched on.
5
Layout of Camera
Lens: The business end of the camera. For a reliable and clear image, ensure that
the lens stays clean and unobstructed. To clean, use a dedicated lens cleaning
solution and cloth, available from all good photography stores.
Infrared LEDs: These give the camera its limited night vision capabilities. These
LEDs act like a fl oodlight, but use light that human eyes cannot see, but which the
camera can.
Stand: This stand can be pivoted to face any direction. Additionally, it can be
attached to the camera via the screw thread on the rear of the camera, allowing
for attachment high on a wall or to a ceiling.
Antenna: Used to transmit the wireless signal to the receiver. For the best results,
the antenna should be as unobstructed as possible - ideally having a clear line of
sight to the receiver.
Lens
Infrared LEDs
Stand
Antenna
