See th applicable manual.
Once the hob position has been dimensioned,
the seal (J) must be affixed to the lower part
of the cooker. This is fastened by means of
four clamps (G), each of which has two tabs
(P) which are inserted in the apert u res (O) in
the hob until they click into place. To secure
the clamp, open the tab (S) outwards a little
as indicated in the figure. Once the seal and
the clamps have been positioned the applian-
ce may be installed in its position.
Use a screwdriver to tighten the screws (T) on
the four clamps and the hob will be perf e c t l y
secured in place. (See drawing 11).
N.B. It is imperative to install the seal under
the brim of the worktop. Failure to install this
may cause the worktop to be exposed to high
temperatures.
In the cases of the models CG.1 4G and CG.1
3G 1P, the clamps must be fitted as shown in
the picture 12 depending on the thickness of
the furniture.
For worktops 30 mm thick or less, use the M5
s c rews supplied as complementary fixation by
i n t roducing them into the circular hole of the
clamp. A fillet shall form in this hole as the
s c rew is introduced in it. This operation should
be done before fastening the clamps to the hob.
To install hob model CGC 4G AI AL, insert the
quick-fix nuts in the screw housings (see dra-
wing 13), connect the clip which corre s
ponds with the height measurement of the
hob unit (20, 30 and 40 mm) and tighten the
s c rews until they are well secure .
Seal Work top Screw
Fastening clip Quick-fix nut
10
Positioning of the oven
Anchoring of the hob
J
O
S
O
P
G
T
Drawing 11
A B
C
D E
20 mm.
30 mm.
40 mm.
A
C
D E
B
Drawing 13
Self-tapping screw for
worktops of 20 and 30
mm. wide
Drawing 12
20/30 mm.
40mm.
61401134/329 ingles 18/7/03 16:55 Página 10
