corresponding to the timed area will
remain lit up.
When the chosen time elapses, the timed
area will switch off and the clock will give a
series of beeps for several seconds. The
time display will show 00 and this will flash
on and off, together with the pilot light of
the hotplate that has disconnected.
If the hotplate that has been switched off is
hot, its display will show an H, otherwise it
will show a 0. Touch any sensor to switch
off the beeping signal.
When more than one hotplate is being
timed simultaneously, the time display will
show the cooking time remaining in the
hotplate to disconnect first by default. If
you wish to check the cooking time remai-
ning in another hotplate, touch its selection
sensor. For a few seconds the display will
show the remaining cooking time for that
hotplate.
Changing the programmed time
The time that you have set can be chan-
ged later on if you so wish.
1 The hotplate being timed must have alre-
ady been selected. The corresponding
decimal point (11) must be lit.
2 Touch the clock sensor (7). The deci-
mal point (11) will come on.
3 Use the or sensors (7/4) to alter
the time.
Disconnecting the clock
If you wish to stop the clock before the pro-
grammed time has elapsed:
1 The hotplate being timed must have alre-
ady been selected. The corresponding
decimal point (11) must be lit.
2 Select the clock sensor (7). The deci-
mal point (11) will come on.
3 Use sensor (4) to reduce the time
down to 00. The clock is cancelled but
the hotplate will remain enabled until
you switch it off.
Switching off quickly
1 The hotplate being timed must have alre-
ady been selected. The corresponding
decimal point (11) must be lit.
2 Select the countdown timer sensor
(7). The corresponding decimal point
(11) must be lit.
3 Touching the and sensors (7 and
4) at the same time cancels the remai-
ning time.
You can also switch the hotplate being
timed off without the programmed time
having elapsed. In this case, the timer will
switch off too.
The clock as a countdown timer
Whenever the clock is not being used in
conjunction with a cooking area, it can be
used as a countdown timer. To do this, you
use the clock without selecting a hotplate.
SWITCHING THE COUNTDOWN TIMER
ON
When the appliance is switched off.
1 Touch the On sensor (1).
19
