8
Setting the Printer’s IP Addressing Parameters
48
PhaserShare Networking
Obtain the information listed in the following table. It might be helpful to write
down this information so you can refer to it during the configuration procedure.
Setting IP parameters from the front panel
1.
When the front panel displays READY TO PRINT, press the
down-arrow button until Menu is highlighted. Press Select.
2.
Press the down-arrow button until Printer Configuration is
highlighted. Press Select.
3.
Press the down-arrow button until Network Settings is
highlighted. Press Select.
4.
Press the down-arrow button until TCP/IP is highlighted. Press
Select.
5. Set the IP address:
a.
Press the down-arrow button until IP Address is highlighted.
Press Select.
b.
Press the left- or right-arrow buttons to highlight the 3-digit part of
the address that you want to set. Press the up- or down-arrow keys
to change the numbers.
c.
When the address is set, press Select.
Information for TCP/IP configuration
Information Comments
Internet (IP) address for
the printer
Format is x.x.x.x, where x represents a decimal number
from 0 - 255.
Network mask If you are unsure, leave this blank; the printer will choose
an appropriate mask.
Broadcast address If you are unsure, leave this blank; the printer computes
an appropriate broadcast address.
The address the printer uses to send broadcast packets.
Regardless of how this parameter is set, the printer
accepts broadcast packets from any of the commonly
used broadcast address conventions.
Gateway IP address Router address. You need this address if you want to
communicate with the printer from anywhere other than
the local network segment.
