Set the ducker function to ON or OFF.
When multiple input signals are simultaneously broadcast, the ducker function automatically attenuates input
signals of other channels with lower priority.
The ducker function does not work among the input channels with the same priority level.
The function does not work either unless the relevant input channels are all set for the ducker function,
permitting all the input signals to be mixed and output.
Assign priority levels of 1 – 8 (high to low) to the selected input signals.
In the normal matrix operation, the priority level given to each Event is based on the priority level set here.
In the 2-channel output operation, the signals of input channel set for Priority 8 are output at Output channel 1
and the signals of input channel set for Priority 1 - 7 at Output channel 2.
The signal set to priority level 8 is handled as BGM in Event settings.
It is possible to assign the same priority level to multiple inputs.
When two or more inputs are simultaneously broadcast in the same zone, the input with higher priority takes
precedence. However, when multiple inputs with the same priority are simultaneously broadcast, they are
allowed to go through according to the priority settings (refer to p. 60 "Priority setting").
Set the priority level higher than level 8 for the input channel to be used for broadcast (e.g. paging using the
ZP-001T) that overrides BGM broadcasts.
44
ON, OFF (default)Setting Range
1 – 8 (default: 8, 7 only when ZP-001T is used)
Setting Range
(only in the 1-channel or 2-channel output operation, when the 900 series module or D-001T is used)
Set how to activate the selected input channel.
NONE (default), C-IN01 – 04 (C-IN01 – 12 when C-001T is used),
VOX (Selectable only when D-001T is used)
Setting Range
Set each of the output zones 1 – 4 to ON or OFF when the SS-9001 is connected to the amplifier.
ON, OFF (default)
Setting Range
(A14) SS-9001 output zone ON/OFF setting (when the 900 series module or D-001T is used)
