Step 6. Fixing the amplifier
Fix the amplifier to the back box with screws
after connecting the power cable and the
speaker cable.
Step 7. Selecting output impedance
Select appropriate output impedance that matches the speaker to be used.
Class 2 wiring may be used.
Since these outputs consist of 8 Ω, 25 V and 70 V via the output transformer (matching transformer) and
direct output of 4 Ω, the connecting method differs in each case. See the following diagram.
Note: Impedances indicated below imply total speaker system (load) impedances.
• When connecting speakers to any one of the outputs of 8 Ω, 25 V or 70 V (BALANCED TRANSFORMER
OUTPUT); connect as illustrated below.
Note
In this case, the LOW-CUT SWITCH should be in "CUT" position. The
amplifier is characteristically flat even in the low frequency range.
Therefore, in TRANS OUTPUT, the acoustic effect and frequency-
response characteristics may be altered. In TRANS OUTPUT, cut off
unnecessary low frequency to obtain the best acoustic condition.
• When connecting speakers to the 4 Ω, output (UNBALANCED DIRECT OUTPUT); connect as illustrated
below.
6
M4 x 10 mm Screw
(3 pcs)
INPUT 1
POWER
ON
250V 3A 250V 6A
OFF
OFF MAX
INPUT 2 INPUT 3
AC FUSE
OFF ON
LOW PASS
OFF ON
HIGH PASS
OUT
631252505001 k 2k4k 8k16k
631252505001 k 2k4k 8k16k
IN
EQUALIZER
OUTPUT FUSE COMPRESSOR
INPUT 4 INPUT 5 INPUT 6 MASTER
12
6
0
6
12
12
6
0
6
12
[W-906A]
Change cable connection for required impedance
according to the speaker used.
[W-912A]
Change cable connection for required impedance
according to the speaker used.
