13
To Install the INF35 and INF55 Sprinkler Riser Assemblies
1
Insert the “hold up” tool into nozzle
notch and riser spring collar.
2
Note locations of alignment
notch and rib.
3
Center the ratchet ring on the
alignment notch and insert riser.
4
Press retainer / o-ring assembly
down below snap ring groove.
Put snap ring, stepped side up,
around riser body.
5
Push snap ring down
until it “snaps” into place.
The multipurpose tool can help.
6
Remove “hold up” tool and lower
riser to retracted position.
To Install the INF34 and INF54 Sprinkler Riser Assembly
To install the INF34 and/or the INF54, follow the steps above except for the steps 2 and 3; those are not necessary.
