A SERVICE OF

logo

4 Replacement Procedures 4.22 Fan/Heat sink/CPU
4.22 Fan/Heat sink/CPU
Removing the Fan/Heat sink/CPU
The following describes the procedure for removing the fan/heat sink/CPU. (See Figure 4-34
to 4-36.)
1. Peel off the glass tape and disconnect the fan cable from the connector CN8771 on
the system board.
2. Remove the following screws securing the CPU hold plate in the reverse order of the
number marked (3 to 1) on the CPU hold plate and remove the CPU hold plate.
M2×4B BIND screw ×3
3. Remove the fan and heat sink.
Fan
Glass tape
CN8771
Fan cable
M2x4B BIND
M2x4B BIND
Heat sink
CPU hold plate
Figure 4-34 Removing the fan/heat sink
4-52 [CONFIDENTIAL] Satellite R20/TECRA M7 Maintenance Manual (960-572)