TL-WR642G 108M Wireless Router User Guide
13
¾ SSID: Enter a value of up to 32 characters. The same SSID must be assigned to all wireless
devices on your network. The default SSID is TP-LINK_XXXXXX(XXXXXX indicates the last
unique six characters of each Router’s MAC address). This value is case-sensitive. For
example, TP-LINK is NOT the same as tp-link.
¾ Region: Select your region from the pull-down list. This field specifies the region where the
wireless function of the router can be used. It may be illegal to use the wireless function of the
router in a region other than one of those specified in this field.
¾ Channel: The current channel in use. This field determines which operating frequency will
be used.
¾ Mode: Indicates the current mode (108Mbps (Dynamic), 108Mbps (Static), 54Mbps
(802.11g), 11Mbps (802.11b)). If you select 108Mbps (Dynamic), it is compatible with
54Mbps (802.11g) and 11Mbps (802.11b). If you select 54Mbps (802.11g), it is compatible
with 11Mbps (802.11b).
These settings are only for basic wireless parameters, for advanced settings, please refer to
Section 5.5: "Wireless."
)
Note:
The change of wireless settings won't take effect until the router reboots! You can reboot it
manually. If you need instructions as to how to do this, please refer to section
14.13.5 Reboot
Click the Next button. You will then see the Finish page (shown in Figure 3-10):
Figure 3-10 Quick Setup - Finish
After finishing all configurations of basic network parameters, please click Finish button to exit
this Quick Setup.
