TL-R480T+ Load Balance Broadband Router User Guide
82
2) Select the Auto-refresh, then the traffic information will be refreshed automatically
during the Packets Statistics Interval. Click the Refresh button to refresh the information
in the table immediately.
Click the Auto-refresh checkbox to refresh automatically.
Click the Refresh button to refresh immediately.
Click the Reset All button to recount again.
Click the Delete All button to delete all the number.
4.13.11 IP NAT Table
Choose menu “System Tools→IP NAT Table”, you will see the IP NAT in the table below:
Figure 4-81
¾ Out Link - The WAN port which links the router.
¾ Protocol Type - The protocol which is used in the link.
¾ IP address - The local or remote IP address to be examined.
¾ Show - To examine the information which the local or remote IP address equals that you
input.
¾ Refresh - To get the latest status and settings of the router
¾ Per page - To set how many information entries a page show.
4.13.12 NAT Source Port Settings
Choose menu “System Tools→NAT Source Port Settings”, you can configure the rang of
exterior port for NAT.
Figure
4-82
Click the Restore button to restore the setting to default value- 1040-65500.
