TP-Link TL-WR740N Manual

A SERVICE OF

next previous

TL-WR740N Wireless Lite N Router

- 23 -

)

Note:

The default PIN code of the Router can be found in its label or the QSS configuration screen as

Figure 4-3.

c).

You will see the following screen when the new device successfully connected to the

network.

)

Note:

a. The QSS LED on the Router will light green for five minutes if the device has been

successfully added to the network.

b. The QSS function cannot be configured if the Wireless Function of the Router is disabled.

Please make sure the Wireless Function is enabled before configuring the QSS.

4.5 Network

Figure 4-5 the Network menu

There are three submenus under the Network menu (shown in Figure 4-5): LAN, WAN and MAC

Clone. Click any of them, and you will be able to configure the corresponding function.

4.5.1 LAN

Choose menu “Network → LAN”, you can configure the IP parameters of the LAN on the screen

as below.