Traxxas, 1100 Klein Road, Plano, TX 75074, Phone: 972-265-8000, Fax: 972-265-8011, e-mail: support@Traxxas.com
10. Remove the clutch bell from the engine using a
2.5mm hex driver. (D)
11. Remove clutch shoes from the flywheel.
12. Remove the flywheel nut (F) using an 8mm hex
wrench (use pliers to hold the flywheel).
Remove the flywheel.
13. Install flywheel with magnet (#6542) and
reinstall flywheel nut, clutch shoes and clutch
bell.
14. Install RPM sensor (#6522) into sensor mount
and secure with the included 2mm screw. (G)
15. Reinstall the EZ-Start assembly onto the
engine.
16. Reinstall the exhaust pipe onto the engine.
17. Reinstall the engine onto the chassis.
18. Remove the upper receiver box using a 2mm
hex driver. (H)
19. Route the RPM sensor wire to the receiver box
and plug into the slot labeled “RPM”. (I)
20. Reconnect the fuel lines and the throttle linkage
and secure the exhaust pipe to the chassis.
