SUMMIT
•
11
2, 3,4
If the status LED doesn’t light
green, check the polarity
of the batteries. Check
rechargeable batteries for
a full charge. If you see any
other flashing signal from the
LED, refer to the chart on page
29 to identify the code.
Use the Right Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries or rechargeable
batteries, such as Nicad or
NiMH (nickel-metal hydride)
batteries, in your transmitter.
Make sure rechargeable
batteries are fully
charged according to the
manufacturer’s instructions.
If you use rechargeable
batteries in your
transmitter, be aware
that when they begin
to lose their charge, they lose
power more quickly than
regular alkaline batteries.
Caution: Discontinue running
your model at the first sign of
weak batteries (flashing red
light) to avoid losing control.
TRAXXAS TQ
i
RADIO SYSTEM
INSTALLING TRANSMITTER BATTERIES
Your TQi transmitter uses 4 AA batteries. The battery compartment
is located in the base of the transmitter.
1. Remove the battery
compartment door by
pressing the tab and sliding the
door open.
2. Install the batteries in the correct orientation
as indicated in the battery compartment.
3. Reinstall the battery door and snap it closed.
4. Turn on the transmitter and check the status
LED for a solid green light.
If the status LED flashes red, the transmitter
batteries may be weak, discharged, or possibly
installed incorrectly. Replace with new or freshly
charged batteries. The status LED does not
indicate the charge level of the battery pack
installed in the model. Refer to the Troubleshooting section on page
29 for more information on the transmitter status LED codes.
CHARGING THE BATTERY PACK
Your model requires two fully charged battery packs. Two (2) Traxxas
Power Cell NiMH batteries are supplied with your model.
A charger is not included with your model. Traxxas recommends the
EZ-Peak Plus charger (part #2933) for quick-charging of the included
batteries. See Traxxas.com for more information about chargers and
the EZ-Peak Plus charger.
INSTALLING BATTERY PACKS
The Summit requires two fully charged battery packs. These batteries
are included with the model.
Battery Installation
1. Open the battery
compartment door by
pressing on the release
tabs.
2. Install the provided
battery pack with the
battery wires facing
the rear of the model.
3. Make sure the
battery is snug in the
compartment. If not,
remove the battery
and make adjustment to the battery retainer tab.
4. Route the battery wire through the slot near the vent.
5. Close the battery door, making sure not to pinch the battery wires.
Be sure both release tabs are fully engaged with the door. Do not
connect the battery packs to the EVX-2 at this time. Note: Always
unplug the batteries and remove from the model after use.
Using Different Battery Configurations
The battery compartments in the Summit are adjustable to
accommodate a large variety of battery packs. Depending on model,
the battery compartments are configured at the factory to accept
either 7-cell NiMH stick packs or 2-Cell LiPo battery packs.
The Summit battery compartments have three key features for
keeping your batteries secure:
1. A foam rubber cushion
2. A spring clip (This is removable for use with taller batteries.)
3. A battery retainer tab (This is adjustable to fit a variety of battery sizes.)
Foam
Cushion
Retainer
Tab
Spring
Clip
Battery Wire Slot
7-cell Battery Orientation
