28
ViewSonic PJ751
Option Menu
Using the OPTION menu, the five items shown in the Table below can
be performed.
Please perform each operation according to the instructions in the
Table.
Item Description
VOLUME
Adjust Volume: High Low
AUTO OFF Adjust AUTO OFF Time:
Long (MAX. 99 min.) Short (Min. 1 min.) (DISABLE: 0
min.) The system automatically enters the standby mode if no signal is received within
the set time. This function is inactive when DISABLE (0 min.) is selected.
WHISPER Select WHISPER Mode:
NORMAL WHISPER
When WHISPER is selected the WHISPER mode is activated. In the WHISPER mode,
acoustic noise and screen brightness are reduced.
LAMP TIME Refer to LAMP TIME: When set, this function displays the total time the projector lamp
has been used since new.
Reset LAMP TIME [Use this function only when the lamp has been replaced!]:
Depress the RESET button for at least 3 seconds while lamp time is being displayed. The
reset menu will then appear. After you replace the lamp with a new lamp, select RESET
on the menu with the button.
• Do not reset the lamp time unless you have replaced the lamp. And, always
reset the lamp time when replacing the lamp.
• Before replacing the lamp, carefully read the lamp maintenance section.
FILTER TIME Refer to FILTER TIME: This function displays the total time the air-filter has
been used since it was installed.
Reset FILTER TIME [Use this function only when the filter is cleaned or replaced!]:
Depress the RESET button for at least 3 seconds while lamp time is being displayed. The
reset menu will then appear. After you replace the filter, select RESET on the menu with
the button.
DEFAULT CANCEL
• Do not reset the filter time unless you have cleaned or replaced the filter. And,
always reset the filter time when cleaning or replacing the filter. The message
functions will not operate properly if the filter time is not reset correctly.
• Before cleaning or replacing the filter, carefully read the descriptions titled
"THE AIR FILTER”.
Example: OPTION Menu
(VOLUME)
