Fig. 12
3. Disconnect high voltage spark wire and control
wire harness female connector.
4. Remove two mountingnuts and screws holding
the ignigtion module to the cover.
Fig. 13
5. Reverse proceedure for install and verify proper
operation.
NOTE: Clear silicone sealant on the control wire
harness female connector will need to be cleaned off.
Apply clear silicone sealant around the connector to
seal it before installation of new ignition module.
DUAL SOLENOID VALVES
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Shut off the gas before servicing the
unit.
All gas joints disturbed during
servicing must be checked for leaks. Check with a
soap and water solution (bubbles). Do not use an open
flame.
1. Remove CONTROL PANEL.
NOTE: Plumbing and type of burner solenoid valves
may vary slightly between different units.
2. Label and disconnect dual solenoid valve
connectors.
Fig. 14
3. Remove retaining screw that is holding dual
solenoid valve body in bracket.
4. Disconnect compression fittings and remove flex
tubing from front of dual solenoid valve.
5. Lift dual solenoid valve out of bracket and
arrange it to access compression fitting in back.
6. Disconnect compression fitting in back of dual
solenoid valve.
RRG SERIES HEAVY DUTY GAS GRIDDLE - REMOVAL AND REPLACEMENT OF PARTS
Page 9 of 24 F45514 (0214)
