
D
49
WallPerfect Flexio 995
Wall paint
GB
49
WallPerfect Flexio 995
Problem Cause Remedy
Spray jet pulsates
•
Coating material in
container running out
•
Nozzle seal worn
•
Air lter heavily soiled
•
Filter clogged at suction
hose
➞ Rell
➞ Replace
➞ Change
➞ Clean lter
Coating material
causes "paint tears"
•
Too much coating material
applied
•
Viscosity of coating material
too low
➞ Turn the material volume
setting to the left
Spray excess material on the
wall using the inking roller
➞ Reduce the quantity of
material and apply in several
layers
Too much fog of
coating material
(Overspray)
•
Distance to the object too
large
•
Too much material quantity
•
At a low quantity of material,
wide spray jet selected
(green)
➞ Reduce distance
➞ Turn the material volume
setting to the left
➞ Switch to narrow jet spray
(red)
Width of paint
spray cannot be
adjusted
•
Adjustment ring is not
connected to the peg on the
air cap
•
Air screen is clogged up
➞ Connect adjustment ring
and peg
➞ Disassemble and clean the
spray head
Poor covering
capacity on the wall
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
•
The material quantity and
spray jet do not correspond
with each other
➞ The material you are
spraying should be at room
temperature
➞ Cross spray (Fig. 8)
➞ Closer to the object
➞ Optimise the settings
Coating material
cannot be atomised
•
Multifunction switch is set to
"Clean"
•
Turbine is defect
➞ Set the multifunction switch
to "ON"
➞ Please contact Wagner
Service