Replacing
Burn, Electrlcal Shock and Fire Hazard
l
Make sure all surface units are OFF before replacing surface units and
c
reflector bowls. Failure to do so can result In burns or electrlcal shock.
l
Do not line the reflector bowls with foil. Fire or electrlcal shock
1.
Turn off all surface units,
2. Line up openings in the reflector
bowl with the surface unit recep-
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
me surface unit terminal into the
receptacle.
tacle and the element
hold down
clip.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite me receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on the surface units.
They also help catch spills. When they are kept clean, they reflect heat
better and look new longer.
If a reflector bowl gets discolored, some of the utensils may not be flat
enough, or some may be too large for the surface unit. In either case, some
of the heat that’s meant to go into or around a utensil goes down and heats
the reflector bowl. This extra heat can discolor it. See Cooking Guide for
fumer Information.
16
