A SERVICE OF

logo

for youirange
CONTROL PANELS AND KNOBS
1.
First make sure knobs are set on OFF then
pull knob stralght off.
/ /
2. Use warm soapy water and a soft cloth to
wipe the panel Rinse and wipe dry.
3.
4.
10
Wash knobs rn warm soapy water. Rinse
well and dry
SURFACE UNITS AND
REFLECTOR BOWLS
REMOVING
1.
Be sure surface units are OFF and COOL.
2.
Lift the edge of the unit opposite the recep-
tacle just enough to clearthe reflector bowl.
Receptacle
3. Pull the surface unit straight away from the
4. Lift out the reflector bowl and trim ring
REPLACING
1.
Be sure surface unit controls are OFF.
‘1 Omening
Receptacle
/
Push the knobs straight back on Make sure
they point to CFF
2. Line
UD
opening in the reflector bowl and
notch in trim ring with the surface unit
receptacle.