PROBLEM
Control knob(s)
will not turn
Self-Cleaning
cycle will not
operate
POSSIBLE CAUSE
You are not pushing in before
turning.
The range clock does not show
the correct time of day.
The Lock Lever is not in the
Clean position-all the way to the
right.
A delayed start time has been
programmed.
SOLUTION
Push control knob(s) in before turning to a
setting.
Reset clock to show the correct time of
day. (See page 11.)
Move Lock Lever all the way to the right.
Wait for the start time to be reached.
Cooking results
The range is not level.
Level range. (See Installation Instruc-
are not what you
tions.)
expected
The oven temperature seems too
Adjusting the oven temperature control.
low or too high.
(See “Adjusting the oven temperature
control” on page 14.)
The oven was not preheated as
Preheat oven if called for in recipe.
the recipe calls for.
The recipe has never been
Use only tested recipes from a reliable
tested or is not from a reliable source.
source.
The pans are not the type or size
Refer to a reliable cookbook for recom-
recommended in the recipe. mended pan type and size.
There is not proper air circulation
Allow 1 l/2 to 2 inches (4-5 cm) on all sides
around pan when baking.
of the pans for air circulation. There must
be a minimum space of 1 inch (2.5 cm).
Flame size does not fit the Adjust flame size to fit cooking utensil.
cooking utensil being used.
When broiling, you have not Completely close oven door.
completely closed the oven door.
The display
shows “PF”
There has been a power failure.
Reset the clock. (See page 11.)
The display
shows “Fl”
Dr “F3”
Call for service. (See Step 3 on page 39.)
38
