Using and replacing the light bulbs
The cooktop light
(motbi SRQ7PEY)
The fluorescent light is on the top of the control
panel. Use the cooktop light switch on the control
panel to turn on the cooktop light.
Eiectricei Shock Hezerd
Make sure power to the range has been
turned OFF at the main power supply
before replacing the fluorescent tube.
Failure to do so could resutt in electrical
shock.
1. Unplug appliance or disconnect at main
electric power supply.
2. Flip up the top of the control panel.
3. Grasp the fluorescent tube at both ends. Turn
the tube away from you until both ends come
out of the receptacles. Repiece with a 20-watt
cool-white fluorescent tube. If the cooktop light
still does not work, the starter may need to be
replaced. The starter is a cylinder-shaped part
located on the left side of the backguard,
behind the light bulb. To remove the starter,
push it in and turn approximately 20’ away
from you. Pull starter out of recessed area.
Replacement starters can be found at stores
that sell fluorescent tubes.
4. Close the top panel. Plug in appliance or re
connect at main power supply.
35
