© 2012 Directed.All rights reserved.
Description Troubleshooting
Module Programming
Off Module has no power. Check the power connections.
Solid red The bus type cannot be detected.
Make sure the connections to the data bus are correct
and insert the key in the ignition switch.
Flashes orange
The vehicle type cannot be
detected.
Insert the key in the ignition switch and turn to the ON
position. You may need to wait up to 10 seconds.
Waiting for keyless.
Remove the key from the ignition switch and press a
keyless button.
The Programming button was held
while powering up.
A reset occured. Release the button. The LED should
turn solid red.
Solid green for
3 seconds
Module was successfully
programmed or is already
programmed.
Normal operation.
Solid orange for
3 seconds
Types 1-5: Module was
successfully programmed without
diagnostics.
Normal operation.
Active Ground While Running
Off Ground While Running (status) off.
Make sure the module was programmed, i.e. the D2D
harness is properly connected or the Ground While
Running (status) wire is connected.
Flashes green Ground While Running (status) on. Normal operation.
Inactive Ground While Running
Flashes green
once (1)
Lock function has been executed.
If it does not flash, the bypass module did not receive
the signal. Verify the connections between the bypass
and the remote starter module.
Flashes green
twice (2)
Unlock function has been
executed.
If it does not flash, the bypass module did not receive
the signal. Verify the connections between the bypass
and the remote starter module.
Flashes green
three (3) times
Trunk release function has been
executed.
If it does not flash, the bypass module did not receive
the signal. Verify the connections between the bypass
and the remote starter module.
Flashes green
four (4) times
AUX1 or AUX2 function has been
executed.
If it does not flash, the bypass module did not receive
the signal. Verify the connections between the bypass
and the remote starter module.
Flashes green
