3 - 10
INSP
ADJ
SPARK ARRESTER CLEANING (For USA)
6. Install:
● Tappet cover (intake side) 1
● O-ring 2
OTE:
Apply the lithium soap base grease on the O-ring.
7. Install:
● Tappet cover (exhaust side)
● O-ring
● Spark plug
● Timing plug
● Crankshaft end cover
OTE:
Apply the lithium soap base grease on the O-ring.
8. Install:
● Air filter case
● Air scoop (right)
SPARK ARRESTER CLEANING (For USA)
WARNING
● Be sure the exhaust pipe and muffler are
cool before cleaning the spark arrester.
● Do not start the engine when cleaning the
exhaust system.
1. Remove:
● Bolt (tailpipe) 1
2. Remove:
● Tailpipe 2
Pull the tailpipe out of the muffler.
3. Clean:
● Spark arrester
Use a wire brush to remove any carbon
deposits from the spark arrester portion
of the muffler body 3 inner surface.
Tap the tailpipe lightly and remove the
carbon deposits from the outside por-
tion a of the tailpipe.
4. Install:
● Tailpipe
Insert the tailpipe into the muffler and
align the bolt hole.
● Bolt (tailpipe)
T
R
.
.
18 Nm (1.8 m · kg, 13 ft · lb)
New
T
R
.
.
18 Nm (1.8 m · kg, 13 ft · lb)
New
T
R
.
.
13 Nm (1.3 m · kg, 9.4 ft · lb)
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
2
1
3
a
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
