Remote Control functionality
19
*1. Indicates the direction(s) in which remote control is supported.
↔ .................... Commands can be transmitted and received in either direction between the PM1D and the remote controller.
Ignored ← ...... This is a parameter not found on the PM1D, so the command will be ignored if it is received from the remote controller.
→ Ignored ...... This is a parameter not found on the remote controller, so the command will be ignored if it is received from the PM1D.
*2. AUX channels on units other than the DM2000 V2 are 1–8. The corresponding MIX channels will depend on the MIX ASSIGN settings in the
REMOTE CONTROL SETUP popup window.
*3. Since the PM1D does not have column 9–column 16, the data is fixed as “ ” (space) on the remote controller.
Mute Master 9-12 ↔ Output Mute Master
Surround Mode ↔ Surround Mode
Input CH Name (Short) ↔ Input CH Name (Short) column1–4
Input CH Name (Long) ↔ Input CH Name (Long)
column1–8
column9–16
*3
Mix CH Name (Short) ↔ Aux CH Name (Short) column1–4
Mix CH Name (Long) ↔ Aux CH Name (Long)
column1–8
column9–16
*3
Matrix CH Name (Short) ↔ Bus CH Name (Short) column1–4
Matrix CH Name (Long) ↔ Bus CH Name (Long)
column1–8
column9–16
*3
Stereo CH Name (Short) L-side only ↔ Stereo CH Name (Short) column1–4
Stereo CH Name (Long) L-side only ↔ Stereo CH Name (Long)
column1–8
column9–16
*3
Scene Now # ↔ Scene Now
Scene Last # ↔ Scene Last
Scene Recall Function ← Scene Recall Function
Scene Clear Function ↔ Scene Clear Function
Scene Store Function ↔ Scene Store Function
Scene Title ↔ Scene Title
Scene Protect ↔ Scene Protect
PM1D
Direction
*1
Remote Controller
Parameter Parameter Notes
