E-86
REMOTE CONTROL FEATURES
■ Recording extra commands
There are two extra commands you can record in a macro:
• Source switching
To record a device action that includes a source switching com-
mand, open the Device menu, hold down the right button (labeled
“ACTION”) and tap the component to which you want to switch.
• Ending with a component control panel
To end a macro with the display of a component, open the Device
menu, hold down the left button (labeled “DEVICE”) and tap the
component you want.
■ Editing macros
You can edit any macro you have recorded.
1
1
Open the macro group that contains the macro.
2
2
Switch to the Edit mode via at the bottom of the
touch screen.
3
3
Tap the macro you want to edit.
The contents of the macro appear.
4
4
Edit the macro.
You can move or delete listed commands or record new
commands.
You can also add delays to the macro (for example, to insert a
short pause between turning on a component and sending
commands to it, allowing the component to warm up).
1 Tap .
2 Tap
or to decrease or increase the length of the delay.
3 Use
and to move the delay to the right position in the
sequence.
5
5
Press the left button to close the macro.
A confirmation screen appears that enables you to save or
cancel the macro.
6
6
Tap .
The macro is ready for use.
■ Organizing macros into groups
You can create as many macro groups as you like. Each group can
contain up to 25 macros.
Open any macro group.
Switch to the Add mode via at the bottom of the
touch screen.
You can create a new group, copy an existing group, or restore
a previously-deleted group.
•
: You add a new group in which you can
record new macros.
• : You copy a group and its macros and use
the copy to create new macros.
• : You restore a deleted group and reuse the
macros.
Tap .
You see a touch screen on which you can create and edit macro
groups. The new group is added to the Macro menu.
