RECORDING
29
English
BASIC
OPERATION
When SCART SET is set to “ON”, signals can pass
through this unit’s SCART connectors even if this unit is
in the standby mode. This allows you to record between
the connected external components (see page 45).
If you experience difficulties recording through this unit’s
SCART connectors, do the following to make sure
SCART SET is set to “ON”.
■ To change the SCART SET setting
1 Press AMP, then press SET MENU on the
remote control.
2 Press / to select MANUAL SETUP, then
press ENTER.
3 Press / repeatedly to select OPTION
MENU, then press ENTER.
4 Press / repeatedly to select SCART
SET, then press ENTER.
5 Press or to select ON, then press
ENTER to complete the setting and return to
OPTION MENU.
Signals can pass through this unit via a SCART cable
whether it is turned on or set to the standby mode.
y
To stop signals on the SCART bus from passing though this unit
when it is in standby mode, select “OFF” in step 5.
RECORDING
Recording in standby mode
(SCART SET setting)
MENU
SET MENU
AMP
then
SET MENU
.;BASICSETUP
.;MANUALSETUP
[]/[]:Up/Down
[ENTER]:Enter
p
p
; MANUAL SETUP
.1 SOUND MENU
2 INPUT MENU
.3 OPTION MENU
[]/[]:Up/Down
[ENTER]:Enter
p
p
A)DISPLAYSET
B)MEMORYGUARD
C)PARAM.INI
.D)SCARTSET
[]/[]:Up/Down
[ENTER]:Enter
3
OPTION
MENU
p
p
