Operation
50
EMU40541
Controls
● Turn the steering wheel fully to port and
starboard. Check that operation is smooth
and unrestricted throughout the whole
range with no binding or excessive free
play.
● Operate the remote control lever several
times to check that there is no hesitation in
its travel. Operation should be smooth over
the complete range of motion.
● Inspect the throttle and shift cable connec-
tions for damage and looseness.
EMU40362
Engine shut-off cord (lanyard)
Check the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU40993
Engine oil
1. Place the outboard motor in a vertical po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01861]
2. Remove the oil dipstick and wipe it clean.
3. Insert the oil dipstick completely and re-
move it again.
4. Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil lev-
el is not at the proper level or if it appears
milky or dirty.
1. Clip
2. Engine shut-off cord (lanyard)
ZMU06979
ZMU06873
1
2
1. Oil dipstick
1. Oil dipstick
2. Upper mark
3. Lower mark
1
ZMU06917
1
2
3
ZMU06918
U6CB10E0.book Page 50 Wednesday, September 30, 2009 9:49 AM
