2 - 24
SPEC
CABLE ROUTING DIAGRAM
Ï Fasten the wire harness, TPS
lead (in the wire harness),
starter motor lead and negative
battery lead to the frame with a
plastic locking tie and cut off
the tie end.
Ì Make sure that the TPS cou-
pler does not go out the chas-
sis.
Ó Fasten the TPS lead to the
frame with a plastic band.
È Fasten the neutral switch lead
and oil hose together with the
plastic locking ties and cut off
the tie ends.
Ô Pass the cylinder head
breather hose through the hose
holder.
Fasten the neutral switch lead
to the frame with a plastic band
ends outward.
Ò Fasten the neutral switch lead
and AC magneto lead to the
frame with a plastic band.
˜ Pass the cylinder head
breather hose on the outside of
the radiator hose 1 and on the
inside of the radiator pipe (radi-
ator hose 4).
ˆ Pass the oil tank breather hose
on the outside of the AC mag-
neto lead, neutral switch lead,
lights switch lead, wire harness
and cylinder head breather
hose.
Ø Pass the wire harness on the
outside of the neutral switch
lead and AC magneto lead.
∏ Fit the brake hose into the
guides on the protector.
ΠPass the wire harness through
the cable guide.
 Fasten the AC magneto lead,
neutral switch lead and lights
switch lead to the cable guide
at their protecting tube with a
plastic locking tie and cut off
the tie end.
Í Pass the carburetor breather
hoses, overflow hose and cool-
ant reservoir tank breather
hose so that the hoses do not
contact the rear shock
absorber.
